Drive System Maintenance; Checking The Front Differential-Oil Level; Changing The Front Differential Oil; Inspecting The Constant-Velocity Boot - Toro Workman HDX-D 07385 Original Instructions Manual

Drive System
Maintenance
Checking the Front
Differential-Oil Level
4-Wheel Drive Models Only
Service Interval: Every 100 hours/Monthly
(whichever comes first)—Check
the level of the front differential oil
(4-wheel drive models only).
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Clean the area around the fill/check plug on side
of the differential
Figure 43
1. Fill/check plug
5. Remove the fill/check plug and check the level
of the oil.
Note:
The oil should be up to hole.
6. If the oil is low, add specified oil.
7. Install the fill/check plug.
(Figure 43).
2. Drain plug
Changing the Front
Differential Oil
4-Wheel Drive Models Only
Service Interval: Every 800 hours (4-wheel drive
Differential oil specification: Mobil 424 hydraulic
fluid
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Clean the area around the drain plug on the side
of the differential
5. Place a drain pan under the drain plug.
6. Remove the drain plug and let the oil flow into
the drain pan.
7. Install and tighten the plug when the oil stops
draining.
8. Clean the area around the fill/check plug on the
bottom of the differential.
9. Remove the fill/check plug and add specified oil
until the oil level is up to the hole.
10. Install the fill/check plug.
Inspecting the
Constant-Velocity Boot
4-Wheel Drive Models Only
g010510
Service Interval: Every 200 hours (4-wheel drive
Inspect the constant-velocity boot for cracks, holes,
or a loose clamp. Contact your Authorized Service
Dealer for repair if you find any damage.
46
models only).
(Figure 43).
models only).