Adjusting The Choke; Converting The Speedometer - Toro Workman HD 07369 Operator's Manual

Figure 63
1. Return spring
2. Engine-governor arm
3. Low-idle stop
4. Throttle lever
WARNING
The engine must be running so that you
can perform the final adjustment of the
accelerator. Running the engine while
performing maintenance on the machine may
cause injury.
To guard against possible personal injury,
engage the parking brake and keep hands,
feet, face, and other parts of your body away
from any moving parts.
3. Start the engine and allow it to warm up to normal
operating temperature. Verify the low idle setting of
1200 ± 100 rpm.
4. Adjust the high idle stop to obtain 3600 ± 50 rpm
when the throttle lever contacts the stop.
5. Stop the engine.
6. Adjust the ball joint on the accelerator cable and/or
cable jam nuts while the throttle lever is against the
high-idle stop to allow 2.54 to 6.35 mm (0.100 to 0.250
inch) of clearance between the accelerator pedal arm
and the top of the diamond tread floor plate, when you
apply a 11.3 kg (25 lb) force to the center of the pedal
(Figure 64). Tighten the locknut.
5. Governor spring
6. High-idle stop
7. Ball joint
1. 2.54 to 6.35 mm (0.100 to 0.250 inch) clearance
Note: The engine must not be running and the return spring
must be attached.

Adjusting the Choke

1. Raise the bed (if equipped) and position the safety
support on the extended-lift cylinder to hold up the
bed.
2. Shut off the engine and engage the parking brake.
3. Loosen the cable-clamp screw securing the cable to
the engine.
4. Push the choke knob to the O
5. Push the choke cable firmly toward the operator's side
of the machine and tighten the cable-clamp screw.

Converting the Speedometer

You can convert the speedometer from mph to km/h or
km/h to mph.
1. Position the machine on a level surface, shut off the
engine, engage the parking brake, and remove the key
from the ignition switch.
2. Remove the hood; refer to
37).
3. Locate the 2 loose wires next to the speedometer.
4. Remove the connector plug from the harness wire and
connect the wires together.
Note: The speedometer switches to km/h or mph.
5. Install the hood.
49
Figure 64
position.
FF
Removing the Hood (page