Converting The Speedometer - Toro 07385 Operator's Manual

1. Loosen the jam nuts securing the clutch cable to the
bracket on the bell housing (Figure 69).
Figure 69
1. Clutch cable
2. Jam nuts
Note: You may remove and rotate the ball joint, if
additional adjustment is required.
2. Disconnect the return spring from the clutch lever.
3. Adjust the jam nuts or ball joint until the back, rear edge
of the clutch pedal is 9.5 ± 0.3 cm (3.75 ± 0.12 inch)
from the top of the floor plate diamond pattern, when
an 1.8 kg (4 lb) force is applied to the pedal (Figure 70).
Figure 70
1. Clutch pedal
Note: Force is applied so the clutch release bearing
lightly contacts the pressure plate fingers.
4. Tighten the jam nuts after the adjustment has been
attained.
5. Recheck the 9.5 ± 0.3 cm (3.75 ± 0.12 inch) dimension
after the jam nuts have been tightened to ensure proper
adjustment. Readjust, if necessary.
6. Connect the return spring to the clutch lever.
Important: Ensure that the rod end is positioned
squarely on the ball, not twisted, and remains
parallel to the clutch pedal after the jam nut is
tightened (Figure 71).
3. Return spring
4. Ball joint
2. 9.5 ± 0.3 cm (3.75 ± 0.12
inch)
1. Clutch cable rod end
2. Clutch pedal
Note: The clutch free play should never be less than
19 mm (0.75 inch).

Converting the Speedometer

You can convert the speedometer from mph to km/h or
km/h to mph.
1. Position the vehicle on a level surface, stop the engine,
engage the parking brake, and remove the key from
the ignition switch.
2. Remove the hood. Refer to
Removing the Hood (page 36).
3. Locate the two loose wires next to the speedometer.
4. Remove the connector plug from the harness wire and
connect the wires together.
The speedometer will switch to km/h or mph.
5. Install the hood.
50
Figure 71
3. Rod end jam nut
4. Parallel