Changing The Hydraulic Fluid And Cleaning The Strainer; Replacing The Hydraulic Filter - Toro Workman HDX-D 07385 Original Instructions Manual

11. Shut off the engine and attachment and check
for leaks.
Changing the Hydraulic
Fluid and Cleaning the
Strainer
Service Interval: Every 800 hours
Hydraulic-fluid capacity: 7 L (7.5 US qt)
Hydraulic-fluid type: Dexron III ATF
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2. Remove the drain plug from the side of the
reservoir, and let the hydraulic fluid flow into a
drain pan (Figure
1. Hydraulic reservoir
3. Note the orientation of the hydraulic hose and
90° fitting connected to the strainer on the side
of the reservoir (Figure
4. Remove the hydraulic hose and 90° fitting.
5. Remove the strainer and clean it by back
flushing it with a clean de-greaser.
Note:
Allow it to air dry before installing.
66).
Figure 66
2. Drain plug
67).
1. Hydraulic strainer
6. Install the strainer.
7. Install the hydraulic hose and 90° fitting to the
strainer in the same orientation.
8. Install and tighten the drain plug.
9. Fill the reservoir with approximately 7 L (7.5
US qt) of the specified hydraulic fluid; refer to
Checking the Transaxle/Hydraulic-Fluid Level
(page 55).
10. Start the engine and operate the machine to fill
the hydraulic system.
g009623
11. Check the hydraulic-fluid level and replenish it,
if required.
Important:
Use only the hydraulic fluid specified.
Other fluids could damage the system.
Replacing the Hydraulic
Filter
Service Interval: After the first 10 hours
Every 800 hours
Important:
Use of any other filter may void the
warranty on some components.
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2. Clean the area around the filter-mounting area.
3. Place a drain pan under the filter and remove
the filter
57
Figure 67
(Figure 68).
g002416