Removing And Installing The Hood - Toro Workman HDX-D 07385 Original Instructions Manual

Figure 27
1. Rear jacking points
Removing and Installing
the Hood
Removing the Hood
1. While grasping the hood in the headlight
openings, lift up the hood to release the lower
mounting tabs from the frame slots
Figure 28
1. Hood
2. Pivot the bottom of the hood upward until you
can pull the top mounting tabs from the frame
slots (Figure 28).
3. Pivot the top of the hood forward and unplug the
wire connectors from the headlights
4. Remove the hood.
Installing the Hood
1. Connect the lights.
2. Insert the top mounting tabs into the frame slots
(Figure
3. Insert the lower mounting tabs into the frame
slots
4. Ensure that the hood is fully engaged in the top,
g009824
sides, and bottom grooves.
(Figure 28).
g010314
37
28).
(Figure 28).
(Figure 28).