Broil Burner Removal And Replacement - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
Figure 163: Rear Cover Shield, Bracket, and Motor (Back-of-Range
View)
1 Screws securing bracket to rear cover shield (4)
2 Screws securing motor to bracket (3)
18. Replace the convection motor, if needed.
4.7.5

Broil Burner Removal and Replacement

This procedure requires access from both the front and the back of
the range. On 48-inch models, the broil burner removal and
replacement procedure is the same for both small and large ovens.
Be sure to check QuickFinder for relevant information, documentation,
and correct part numbers when replacing any of these components.
Hot Surfaces
The oven broil burner components and interior surfaces of the oven
may be hot and can cause burns. Do not service the range when
these components are hot.
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
Eye Protection
To protect your eyes from debris, it is recommended to wear
protective eye wear at all times when removing or installing
components inside the oven cavity.
Fiberglass
Wear gloves when handling fiberglass insulation.
Figure 164: Broil Reflector Plate
Figure 165: Broil Element
Figure 166: Bracket
Page 83 of 95