Door Hinge Removal And Replacement - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
6. Remove and retain the three screws at the bottom of the door
(see Figure 182).
Figure 182: Screws at Bottom of Door
1 Location of screws (3) at bottom of door
7. Gently lift front door panel off the door.
8. At the back side of the front door panel, at both the left and right
sides, remove and retain the two hex head cap screws and
washers (see Figure 183). This will detach the endcaps from the
door assembly.
9. After removing the right and left endcaps, pull the door handle
tube out from the endcaps.
10. Replace the door handle components if needed.
11. After replacing door handle components, install the oven door and
test for proper positioning - follow all warnings and steps for
Installing the Door, page 77.
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
Figure 183: Hex Head Cap Screws and Washers
1 Hex head cap screws and washers (4 of each) – left
side shown
4.7.9

Door Hinge Removal and Replacement

Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
When the door is removed from the range, never release locking
levers or try to close the hinges. Without the weight of the door, the
powerful springs will snap the hinges shut with great force.
Sharp Components
Wear gloves when removing the door hinge
Page 90 of 95