Removing Spill Trays; Removing Heat Shields - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
4.2.2

Removing Spill Trays

m
Caution
Fragile Component
Porcelain enamel spill trays are fragile, so do not over-torque spill tray
screws to avoid damaging the porcelain.
1. Push each ignition wire downward through its respective
receptacle, as you carefully lift out each spill tray (see Figure 29
and Figure 30).
Figure 29: Typical Spill Tray
Figure 30: Removing the Spill Trays (Ignition Wire Shown)
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
4.2.3

Removing Heat Shields

Figure 31: Typical Heat Shields
Sharp Components – Gloves Recommended
Use gloves when removing or installing a heat shield, as the edges
may be sharp.
1. Remove and retain the screws that secure the heat shield onto the
range.
2. Use gloves while you carefully lift and remove the heat shield(s).
See Figure 32.
Figure 32: Removing the Heat Shield
Page 23 of 95