Grill Hot Surface Igniter Removal And Replacement; Grill Electrode Removal And Replacement - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
4.4.3

Grill Hot Surface Igniter Removal and Replacement

Figure 60: Grill Hot Surface Igniter (HSI)
8. Make sure the HSI wire connector has been detached from under
the burner box (per step 5).
9. Remove and retain the screw that secures the HSI onto the burner
box chassis (see Figure 61), and then gently pull the HSI out
(see Figure 60).
Figure 61: Screws for Removing the HSI and Electrode
1 Electrode screw (shown securing electrode onto
electrode bracket)
2 HSI screw (shown securing HSI onto burner box)
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
4.4.4

Grill Electrode Removal and Replacement

On the grill, the electrode functions as a flame sensor – that is, if the
electrode does not heat up enough in a short time frame, the
electrode will close the solenoid valve to avoid gas build-up in the grill
burner. See Figure 62.
Figure 62: Electrode
1 Electrode terminal
2 Location of screw that secures electrode onto
electrode bracket
10. Make sure the electrode spade connector has been detached
from the electrode terminal (from under the burner box).
11. Remove and retain the screw that secures the electrode onto the
electrode bracket (see Figure 61 and Figure 62), and then remove
the electrode.
Page 35 of 95