Crossmember Cover Removal And Replacement; Terminal Block Removal And Replacement - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
4.6.3

Crossmember Cover Removal and Replacement

You will need to remove the crossmember cover if you are removing a
wire connector to the bake burner HSI or bake burner electrode.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 136: Typical Crossmember Cover
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Remove and retain the screws from the crossmember cover (see
Figure 136 and Figure 133, page 69).
3. [If removing the crossmember cover]: Push the power cord
through the receptacle on the crossmember cover, so that you can
remove it without having to detach the power cord wiring at the
terminal block.
4. [If replacing the crossmember cover]: You will need to detach the
power cord from the terminal block first before replacing the
crossmember cover (see Electrical Wiring Connections at the
Terminal Block, page 71).
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
4.6.4

Terminal Block Removal and Replacement

At the terminal box (junction box), replace the terminal block in the
event the terminal threads are stripped, or if there is any other
damage to the component.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
Figure 137: Typical Terminal Block Positioned In the Terminal Box
2. Detach the wire leads from each terminal on the terminal block
(see Figure 137). Retain the washers and nuts (see Figure 138),
and make a note of how all the wires are connected to the
different terminals.
Page 70 of 95