Regulator Removal And Replacement - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
Figure 102: Oven Temperature Gauge (Back Side Shown)
1 Nuts with lockwashers (2) on studs (2)
2 Temperature gauge
3 Mounting bracket
4 Four-pin wire connector
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG

4.5.13 Regulator Removal and Replacement

Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
NOTE: When replacing the regulator, if the range has been converted
for use with LP gas, make sure to install the correct regulator (cap)
fitting. Refer to the instructions in the PLPKIT kit for details.
Figure 103: Regulator with Typical Fittings and Gas Flex Line
1 Gas flex line
2 Hex nut on gas flex line
3 Flared adapter
4 Large nut on regulator
5 Regulator
6 Connecting pipe
7 T-connector
8 Manifold pipe
9 Flared adapter
Page 54 of 95