Door Latch Removal And Replacement - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
Figure 111: Ignition (Spark) Module – Typical Models Shown

4.5.19 Door Latch Removal and Replacement

Removing and replacing the door latch requires access from both the
top and front of the range.
Depending on the model and index number of the range, a
replacement door latch may or may not require an adapter harness to
be installed.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 112: Door Latch – Typical Models Shown
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Follow all steps in Accessing Components under the Maintop,
page 21.
3. Remove the corresponding oven door (see Oven Door Removal,
Installation, page 77).
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
4. If obstructing access to the door latch access panel, remove the
burner support rail (with jet holder assemblies attached) by
following the steps in Removing the Burner Support Rail, page 24.
NOTE: Depending on the model range, if the door latch and/or
plunger switch is located under the griddle/grill you need you may
need to remove the griddle/grill first in order to gain access.
See Griddle Removal and Replacement, page 26 and
Grill Components – Removal and Replacement, page 32.
5. Remove and retain the single screw that holds the access panel to
the range chassis (see Figure 113).
6. Lift the access panel up, and detach its two tabs from the chassis
(see Figure 113, page 60).
7. Remove and retain the two T-20 screws under the front control
panel (see Figure 114).
8. Gently lift the latch out of the cavity (see Figure 115).
Figure 113: Door Latch Access Panel (Small Oven Access Panel
Shown)
1 Tabs (2)
2 Screw
Page 60 of 95