Aligning The Door - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
and rest straight on the front of the range when closed. If the door
does not operate correctly, verify that the hinges are properly
seated into the hinge slots, and that the locking levers are fully
engaged into the slots. If the door is not aligned correctly, see

Aligning the Door.

4.7.3.3 Aligning the Door
On models that have an alignment mechanism as a part of the hinge
receiver, you can adjust the door alignment by using the alignment
screw that is located below each hinge / hinge receiver slot.
1. Make sure the door is installed correctly so it will not pose any
danger by falling while adjusting the screw (see Installing the
Door, page 77).
2. Locate the alignment screw below the door hinge (see
Figure 150 and Figure 151).
3. Use a T-27 driver to turn the alignment screw until the door is
properly aligned.
Figure 150: Alignment Screw (View at Small Door of 48-Inch Range)
1 Alignment screw
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
Figure 151: Alignment Screw (Shown with Door Removed for Clarity)
1 Slot for hinge
2 Hinge receiver screw (do not rotate this screw as it
is not for door alignment)
3 Door alignment screw
Page 78 of 95