Oven Temperature Selector Removal And Replacement - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:

4.5.10 Oven Temperature Selector Removal and Replacement

For 48-inch ranges, there is a dedicated oven temperature selector for
each of the two ovens. This procedure covers the removal and
replacement for both oven temperature selectors.
Depending on the FD number and model, the oven temperature
selector may or may not be fastened with a clip-shaped bracket (see
Figure 94).
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 93: Small Oven Temperature Selector (Typical Models Shown)
Figure 94: Front and Back of Small Oven Temperature Selector (Typical
Model Shown with Retaining Bracket)
1 Retaining bracket
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
Figure 95: Large Oven Temperature Selector (Typical Models Shown)
Figure 96: Front and Back of Large Oven Temperature Selector (Typical
Model Shown with Retaining Bracket)
1 Retaining bracket
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Follow all steps in Accessing Components under the Maintop,
page 21.
3. Remove knob from valve stem by slowly pulling knob straight out,
away from control panel.
4. If obstructing access to the oven temperature selector, remove the
burner support rail (with jet holder assemblies attached) by
following the steps in the Removing the Burner Support Rail,
page 24.
Page 51 of 95