Service Manual for Thermador Pro Grand Dual Fuel Ranges:
2
OPERATION
2.1 Knobs and Controls
The control knobs each have an icon to identify the location on the
range. The two standard burners are located on the right side of the
control panel (see Figure 2). The two ExtraLow (XLO) burners are
located on the left side (see Figure 3).
2.1.1
Standard Burner Knob
1. Press a control knob in, and turn counter-clockwise to HI setting.
The igniter for the burner clicks while sparking until flame ignition.
Burner should ignite within 4 seconds.
2. For the standard burners, rotate the knob to any setting between
HI and SIM.
NOTE: The blue LED indicator lights up when burners are lit.
Figure 2: Standard Burner Control Knob
2.1.2
ExtraLow Burner Knob
When in XLO mode - the very lowest flame setting, the flame cycles
on for approximately 8 seconds and then turns off for 52 seconds of
each minute.
1. Press a control knob in, and turn counter-clockwise to HI setting.
The igniter for the burner clicks while sparking until flame ignition.
Burner should ignite within 4 seconds.
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
2. In XLO mode, the knob can be set between SIM and XLO for a
variable range of low heat (see Figure 3).
Figure 3: XLO Burner Control Knob
2.1.3
Griddle Control Knob
The griddle knob controls the temperature to the griddle, from 150° F
to 500° F (see Figure 4).
Press and turn the knob clockwise to select a setting.
Figure 4: Griddle Control Knob
Page 9 of 95