Table of Contents
Advertisement
DO-IT-YOURSELF MAINTENANCE
OVEN LIGHT BULB REPLACEMENT
Replace only with a 40 watt, 120 volt appliance light bulb. DO NOT USE a
standard household light bulb in any oven.
TO REPLACE THE LIGHT BULB:
1. Turn oven light switch to the off position. Let bulb and cover cool
completely.
2. Remove the light cover. Turn the cover to the left (counterclockwise) to
unscrew it.
3. Remove the burnt out bulb. Replace it with a 40 watt, appliance light
bulb only.
4. Replace cover. Turn circuit back on, if need be. (See Caution.)
POWER FAILURE
In the event of a power failure, only the standard burners
can be lighted manually. It is necessary to light each
standard burner individually.
If the cooktop is being used when the power failure
occurs, turn all of the burner control knobs to the OFF
position. Then, the standard burners can be lighted by
holding a match at the ports and turning the control knob
to the HI position. Wait until the flame is burning all the
INTERMITTENT OR CONSTANT IGNITER SPARKING
Intermittent or constant sparking of the sealed gas surface burners can result from a number of preventable
conditions. Eliminate these conditions as indicated in the chart.
SYMPTOM
Intermittent sparking
Constant Sparking
SECTION SEVEN: BEFORE CALLING FOR SERVICE
CAUSE
• Improper fit of burner cap into
flame spreader.
• Ceramic igniter is wet or dirty.
• Burner ports are clogged.
• Range is not properly grounded.
• Electrical power supply is
incorrectly polarized.
Page 39
Before replacing the light bulb,
be certain the Oven Light
Switch is in the off position.
Let bulb and cover cool com-
pletely before touching. If the
light bulb glass comes loose
from the base, turn the
power to the oven OFF at
the circuit breaker panel,
before attempting to re-
move the bulb base from
the socket.
way around the burner cap before adjusting the flame to
the desired height.
®
The two ExtraLow
burners on the far left side, cannot be
used during a power failure. Be sure to turn them OFF
if a power failure occurs, as they will not turn back on until
both control knobs are turned OFF and then turned back
on again. See "What to do if you Smell Gas", inside front
cover.
REMEDY
•
Align burner cap properly
on flame spreader.
•
Carefully dry or clean igniter.
•
Clean ports on flame spreader
with a wire, a needle or
straightened paper clip.
•
Refer to Installation Instructions.
Have a qualified electrician
ground the range properly.
•
Refer to Installation Instructions.
Have a qualified electrician
ground the range properly.
!
CAUTION:
Hide quick links:
Advertisement
Table of Contents
