Suzuki RV125 Service Manual page 114

THROTTLE POSITION SENSOR POSITIONING
• Install the throttle position sensor with the flats on the throttle
shaft end securely engaged with the slot on the throttle posi-
tion sensor.
• Measure the resistance
sensor terminals as shown in the illustration.
$ Throttle position sensor resistance
• Measure the resistance
sensor terminals as shown in the illustration.
• Fully open the throttle valve with the throttle lever.
• Position the throttle position sensor until resistance
is approx. 3.09 – 4.63 kΩ.
• When the resistance
throttle position sensor mounting screws.
$ Throttle position sensor resistance
• After the assembly and installation on the engine have been
completed, perform the following adjustment.
* Engine idle speed ("2-8)
* Throttle cable play ("2-8)
Ω1
between the throttle position
Ω1
Ω2
between the throttle position
Ω2
is within specification, tighten the
Ω2
Approx. 3.09 – 4.63 kΩ Ω Ω Ω
: Approx. 5 kΩ Ω Ω Ω
Ω2
:
FUEL AND LUBRICATION SYSTEM
Ω2
4-13
Ω1