Suzuki RV125 Service Manual page 49

CYLINDER HEAD
• Remove the cylinder head nuts (M6).
• Remove the cylinder head nuts (M8) diagonally.
• Remove the cylinder head.
NOTE:
If the cylinder head does not come off, lightly tap on the finless
portion of it with a plastic hammer.
CYLINDER
• Remove the gasket 1.
• Remove the cam chain guide 2.
• Remove the cylinder by removing the cylinder base nuts.
NOTE:
If the cylinder does not come off, lightly tap on the finless portion
of it with a plastic hammer.
PISTON
• Place a clean rag over the cylinder base to prevent the piston
pin circlip 3 from dropping into the crankcase. Then, remove
the piston pin circlip 3.
• Remove the piston pin.
NOTE:
Use the special tool if necessary.
% 09910-34510: Piston pin puller
• Remove the piston.
ENGINE 3-13