Suzuki RV125 Service Manual page 99

CYLINDER HEAD COVER
• Pour engine oil in each oil pocket in the cylinder head.
• Install the camshaft end cap 1.
• Clean the mating surfaces of the cylinder head and head
cover.
• Install the dowel pins.
• Apply SUZUKI BOND uniformly to the mating surface of the
cylinder head cover and install it within a few minutes.
-99000-31230: SUZUKI BOND "1216B"
1216B 1216B
NOTE:
When installing the cylinder head cover, the piston must be at
the top dead center on the compression stroke.
• Tighten the cylinder head cover bolts to the specified torque
with a torque wrench diagonally.
# Cylinder head cover bolt: 10 N·m (1.0 kgf-m)
"
Install the gasket washer to the bolt A.
"
Be sure to check the valve clearance. (!2-5)
1216
ENGINE 3-63