Setting The System Time And Date Manually - Cisco 1120 Installation Manual

Chapter 4 Administering the Cisco 1120 Secure Access Control Server
Step 3 At the
If you entered No, the system displays a confirmation of DHCP and the message
Step 4
reconfigured
If you entered Yes, to specify the CSACS 1120 IP address:
a.
b.
c.
d.
Review the information displayed, and at the
Step 5
press Enter.
Result: The CSACS 1120 restarts. The console displays:
New ip address is set.
At the
Step 6
Tip
At the
Step 7
to the CSACS 1120, and press Enter.
Result: If successful, the system displays the ping statistics. Once again the system displays the
network connectivity [Yes]:
Step 8 If network connectivity is successful in the previous two steps, at the
[Yes]: prompt
Tip
Result: The CSACS 1120 restarts services, and displays the system prompt.

Setting the System Time and Date Manually

You can set and maintain the system date and time by using one of two methods:
•
•
To set the CSACS 1120 system time and date by using an NTP, see
with
OL-19455-01
Use Static IP Address [Yes]:
appears on the console. Continue the procedure with
At the
IP Address [xx.xx.xx.xx]:
At the
Subnet Mask [xx.xx.xx.xx]:
At the
Default Gateway [xx.xx.xx.xx]:
At the
DNS Servers [xx.xx.xx.xx]:
use (separate each by a single space), and press Enter.
Result: The console displays the new configuration information and the following message:
IP Address is reconfigured.
Test network connectivity [Yes]:
This step executes a ping command to ensure the connectivity of the .
Enter hostname or IP address:
, enter , and press Enter.
N
The system will continue to provide you with the opportunity to test network connectivity until
you answer N. This procedure gives you an opportunity, if required, to correct network
connections or retype the IP address.
Set the time and date manually.
Assign a network time protocol (NTP) server with which the system synchronizes its date and time.
NTP.
prompt, enter for yes or
Y
prompt, enter the IP address, and press Enter.
prompt, enter the subnet mask, and press Enter.
prompt, enter the default gateway, and press Enter.
prompt, enter the address of any DNS servers you intend to
Confirm the changes? [Y]:
prompt, enter
prompt, enter the IP address or hostname of a device connected
prompt.
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
Reconfiguring CSACS 1120 System Parameters
for No, and press Enter.
N
IP Address is
Step 5.
prompt, enter
, and press Enter.
Y
Test network connectivity
Setting the System Time and Date
and
Y,
Test
4-21