Seats - Cadillac 60 Series 1963 Shop Manual

16-50
BODY
remove assembly. Be sure to disconnect switch
terminal blocks from switch assembly.
2. To install, reverse removal procedure, Sec-
tions D-D and E-E in Fig. 16-54.
SEATS
This - section provides information on removal and installation procedures for manually oper -
ated seats, two-way electric seats, six-way electric seats, bucket-type seats, and finally rear
seats. Additional information on electric seats is given in the body electrical section.
62. Front Seat Assembly
(Manually Operated)
Manually operated front seat adjusters provide
fore and aft movement of the seat. When the knob
at the left of the seat is pulled up, the seat ad-
justers unlock, permitting a horizontal travel of
seat. When the seat is in the desired position, the
knob is released and the seat adjusters are
locked.
a. Front Seat Assembly (With Attached Adjusters)
Removal and Installation
1. Remove sill plates and turn back floor
covering.
2. Remove four seat adjuster-to-floor pan at-
taching bolts from each adjuster, Fig. 16-57.
3. With aid of a helper, remove seat assembly
from body.
4. To install, replace parts in reverse se-
quence. On 6229, 6239 and 6257 styles, make sure
spacers are installed between adjuster front and
rear supports and floor pan, Fig. 16-57.
b. Front Seat Adjuster (Manual)
Removal and Installation
1. Remove seat assembly with attached seat
adjusters from body and place upside down on a
clean protected surface.
Seat Bottom Frame
Seat Adjuster
Spacer (6229,
6239 and 6257)
2. When removing left adjuster, it is necessary
to remove seat adjuster control knob.
3. Squeeze hooked end of seat adjuster locking
wire together and slide retaining spring back over
hump in locking wire, remove wire from retainer
on seat bottom frame and disengage locking wire
from seat adjuster.
4. Remove adjuster-to-seat bottom frame front
and rear attaching bolts and remove seat adjuster
from seat assembly, Fig. 16-58.
5. To install, reverse removal procedure.
6. Check operation of seat assembly. If right
adjuster does not lock or unlock satisfactorily
when control handle on left adjuster is operated,
remove locking wire retainer from hole in seat
bottom frame and adjust retainer by selecting
another hole to obtain proper tension in locking
wire.
63. Front Seat Assembly
(Two-Way Electric)
The electrically operated two-way front seat
assembly can be moved forward or rearward by
means of a manually operated seat control switch.
Seat Bottom Frame
Fig. 16-57 Front Seat Adjuster
Fig. 16-58 Manual Seat Adjuster Attachment