Cadillac 60 Series 1963 Shop Manual page 145

6-52
HYDRA-MATIC TRANSMISSION
J-8092. Note location of oil hole in bushing as it
is being removed.
2. Stand center bearing support upright with
flange end up.
3. Install new bushing using Driver Head, J-
8400-12, and Handle, J-8092. Oil hole in bushing
must line up with oil hole in center bearing sup-
port, Fig. 6-92.
j. Rear Unit Clutch Cover, Fig. 6-93
1. Place clutch cover on bench with bushing
end up.
2. Locate split in bushing and start point of
Chisel, J-8400-1, beside split with flat side of
Chisel facing in.
3. Tap Chisel with hammer until split in bush-
ing opens up, then remove bushing.
4. Install new bushing using Driver Head, J-
8400-14, and Handle, J-8092.
k. Reverse Sun Gear, Fig. 6-94
1. Place reverse drive flange on bench with
sun gear down.
2. Locate split in bushing and start point of
Chisel, J-8400-1, beside split with flat side of
Chisel facing in.
3. Tap Chisel with hammer until split in bush-
ing opens up, then remove bushing.
4. Install new bushing using Driver Head, J-
8400-16, and Handle, J-8092.
• I N
j I
1
J-8092
r
if
Fig. 6-94 Installing Bushing in Reverse Sun Gear
i. Reverse Internal Gear, Fig. 6-95
1. Place reverse internal gear on large end pf
Support, J-8400-30, with gear teeth down.
2. Locate split in bushing and start point bf
Chisel, J-8400-1, beside split with flat side J)f
Chisel facing in.
3. Tap Chisel with hammer until split in buss-
ing opens up, then remove bushing.
4. Install new bushing using Driver Head,
8400-17, and Handle, J-8092.
m. Extension Housing, Figs. 6-96, 6-97
1. Remove oil seal as outlined in Note l\.
2. Place extension housing on bench with output
shaft end up.
3. Locate split in upper bushing and start poult
of Chisel, J-8400-1, beside split with flat side <\f
Chisel facing in.
Fig. 6-93 Installing Bushing in Rear Unit Clutch Cover Fig. 6-95 Installing Bushing in Reverse Internal Gear