Cadillac 60 Series 1963 Shop Manual page 320

ELECTRICAL SYSTEM
12-39
'A" Normal
Height
Center Of Hot Spot L. H.
Inner Lamp (High Beam)
Center Of Hot Spot R. H.
Inner Lamp (High Beam)
-#-6-5/16" 57-3/16"
2"
,-- Center Line
Headlamps And
Driving Lamps
6-5/16"-*>
Hot Spot for L. H. Headlamp (Outer)
(Lower Beam) Top Of Hot Spot On Horizontal
Center Line of Headlamp And L. H. Edge Of Hot
Spot On Vertical Center Line Of Headlamp
Center Line Of Car
Hot Spot For R. H. Headlamp (Outer) (Lower
Beam). Top Of Hot Spot On Horizontal Center
Line Of Headlamp And L. H. Edge Of Hot Spot
On Vertical Center Line Of Headlamp
Floor Level
Inner Lamps Are High Beam Lamps
Only, Outer Lamps Are Both High And
Low Beam But Are To Be Aimed On Low
Beam Only
Fig. 12-63 Headlamp Aiming - Screen
b. Installation
1. Route parking lamp wire through bumper
opening and connect wire to underhood harness
connector.
2. Install parking lamp from front.
3. Tighten inner mounting bracket bolt to
bumper.
4. Install bracket and secure parking lamp to
bracket with two mounting nuts.
52. Back-Up, Tail, Stop and Signal Lamp
Assembly Removal and Installation
a. Removal
1. Disconnect feed wire from plastic connector
located on lower rear panel of trunk. Disconnect
license lamp.
2. Loosen bumper and pull away from body
slightly to gain access to mounting screws.
Ignition Switch Bulb Cluster Bulbs
Fig. 12-64 Cluster Bulb Locations