Cadillac 60 Series 1963 Shop Manual page 275

11-4
ENGINE COOLING
2. Install the two top radiator to cradle clamps.
3. Connect the two transmission cooler lines
at lower rear of radiator.
4. Connect upper and lower radiator hoses.
5. Fill cooling system, adding anti-freeze if
necessary. Also add inhibitor and sealer.
6. Run engine sufficiently to pump coolant
through entire system and check radiator and
transmission fluid levels.
7. Check cooling system and transmission
cooler lines for leaks.
c. Removal (Air Conditioned Cars)
1. Drain coolant from radiator.
2. Disconnect upper radiator hose at thermo-
stat housing and lower radiator hose at water
pump.
3. Disconnect two transmission cooler lines
from rear of radiator at lower tank, and plug
ends of lines to prevent loss of transmission
fluid.
4. Remove the two bottom and top cradle to
shroud clamps. This will allow shroud to be
pushed away from radiator.
5. Remove radiator by lifting straight up.
d. Installation (Air Conditioned Cars)
1. Place radiator in position.
2. Move shroud into place and connect the two
bottom and two top cradle to shroud clamps.
3. Connect two transmission cooler lines at
lower rear of radiator.
4. Connect upper and lower radiator hoses.
5. Fill cooling system, adding anti-freeze if
necessary. Also add inhibitor and sealer.
6. Run engine sufficiently to pump coolant
through entire system and check radiator and
transmission fluid levels.
7. Check cooling system and transmission
cooler lines for leaks.
•Screw
•Housing
-Gasket
Thermostat
Cylinder Head
Water Outlet Pipe
Spacer
Screw
Loclcwasher
Fan Blade
Fig. 11-2 Water Pump Components Disassembled