Cadillac 60 Series 1963 Shop Manual page 136

HYDRA-MATIC TRANSMISSION
)-43
8. Install detent valve, small end first, and
detent plug.
9. Attach TV lever stop bracket to manual body
with two screws.
i. Control Valve Assembly—Assembly, Fig. 6-68
1. Install thermostatic feed valve element into
channel plate.
2. Position channel plate to case spacer on
channel plate.
3. Position manual valve body on channel plate
to case spacer, and install three attaching screws
finger tight.
NOTE: Do not tighten any valve body as-
sembly screws until all individual bodies have
been installed and aligned.
4. Install and align channel plate-to-valve body
spacer on channel plate.
5. Position shift valve body on channel plate-to-
valve body spacer opposite manual body, and in-
stall three attaching screws finger tight.
6. Install coupling valve body with two attaching
screws finger tight.
7. Install five case mounting screws in their
proper holes in control valve assembly to align
spacers, and tighten all 8 body attaching screws.
8. Install manual valve in manual valve body.
18. Assembly of Transmission to
Install Major Components
a. Install Center Bearing Support
Neutral Clutch and Rear Unit Assemblies
1. Install neutral clutch drum stationary stop
Stationary Stop Key (Neutral Clutch Drum)
-Transmission Case
^ t *
Stationary Sto
(Reverse Stationary
Fig. 6-73 Installing Overrun Band
key in transmission case using petrolatum to
hold in place, Fig. 6-72.
2. Install overrun band in transmission case
and attach band to stationary anchor in case,
Fig. 6-73.
3. Install reverse stationary cone stop key in
transmission case using petrolatum to hold in
place, Fig. 6-73.
4. Remove neutral clutch and rear unit assem-
bly from holding fixture and install in trans-
mission case by inserting output shaft through
front of transmission case. Use guide lines on
rear unit drum to align neutral clutch drum lo-
cating slot with stationary stop key in trans-
mission case, Fig. 6-74.
If unit does not go in far enough so that snap
ring groove in transmission case is visible ahead
of center bearing support, slight pressure may be
necessary to force unit into place.
5. Install large snap ring that holds center
Fig. 6-72 Installing Stationary Stop Key
Fig. 6-74 Aligning Center Bearing Support Key Slot