Cadillac 60 Series 1963 Shop Manual page 111

6-18
HYDRA-MATIC TRANSMISSION
17. Install parking brake relay lever and re-
tracting spring in position in frame. Connect
brake cables to lever and adjust cables. See Sec-
tion 8, Note 2.
18. Adjust manual and TV linkage as described
in Note 7.
19. Check torque of engine front cushion-to-
frame nuts. These nuts should be tightened to
90 foot-pounds.
20. With rear cushion-to-frame cross member
attaching screws loose, pry transmission exten-
sion housing retainer up off cross member to
allow engine to move backward as far as possible.
21. Scribe a line on underside of cross member
at rear edge of rectangular plate.
22. Place a bar at rear of engine rear cushion
front attaching screw and pry engine and trans-
mission assembly as far forward as possible.
23. With engine in this position, scribe a second
line on cross member at rear edge of plate.
24. Allow engine to move rearward until rear
edge of plate is positioned halfway between the
two scribed lines and then tighten rear cushion-
to-frame attaching screws to 55 foot-pounds.
25. Install each engine side support cushion
in frame slots, and loosely install flat washer,
lock washer, and retaining nut.
26. Slide each cushion support toward bell
housing until cushion support just touches housing.
NOTE: Be sure that underside of cushion
support bracket is flat against frame.
27. Scribe a reference line on frame adjacent
to each bracket.
28. Slide each bracket 1/16 inch inboard toward
bell housing letting rubber cushion ride up bell
housing.
29. Tighten each retaining nut to 25 foot-pounds
compressing rubber cushion until bracket again
lies flat on frame member.
30. If either bracket is not 1/16 inch inboard of
reference line after retaining nuts are tightened,
repeat above procedure.
31. Lower car to floor and connect battery.
32. Install filler pipe bracket to exhaust mani-
fold screw.
33. Add fluid to transmission as required.
Flywheel Housing Assembly
^sTorus Cover Assembly
Steel Backing Washer
Steel Backing Washer
/ Snap Ring
Front Sun Gear
Intermediate Shaft Snap Ring
Mainshaft Inner Snap Ring
Mainshaft Outer Snap Ring
Flywheel Housing Seal
Ring Seal (Flywheel Housing to Case)
Front Internal Gear
Needle Thrust Bearing
Steel Selective Washer
Bronze Thrust Washer
Driving Torus Assembly
Retaining Pin
Driven Torus Assembly
Torus Check Valve Spring
Torus Check Valve
Ring Seal (Flywheel to Torus Cover)
Flywheel
Fig. 6-20 Flywheel Torus Members Cover and Housing Disassembled