Cadillac 60 Series 1963 Shop Manual page 420

HEATING AND AIR CONDITIONING
13-39
Clutch Coil and
Housing Assembly
Snap Ring Pliers
J-6435 (-26)
Retainer Ring'
Fig. 13-40 Removing Coil Housing Retainer Ring
5. Install clutch plate and hub assembly as
described in Note 32b.
36. Compressor Shaft Seal Assembly
Removal and Installation
a. Removal
1. Remove clutch plate and hub assembly as
described in Note 32a.
2. Remove seal seat retainer ring using Snap
Ring Pliers, J-5403, (#21), Fig. 13-41.
NOTE: Illustration shows coil and housing
removed, but this removal is not necessary.
Seal
Remover
Seat
J-9393 <
U
> Seal Seat
Fig. 13-42 Removing Seal Seat
3. Remove seal seat using Seal Seat Remover
and Installer, J-9393, Fig. 13-42. Grasp seal
seat with tool flanges and pull straight up on end
of tool to remove seal seat.
4. Remove shaft seal assembly using Seal Re-
mover and Installer, J-9392, Fig. 13-43. Press
down on tool to overcome seal spring pressure
and twist tool clockwise to engage tabs on seal
assembly with locking tangs on tool. Remove
seal assembly by pulling straight out from shaft.
5. Remove O-ring from interior of front head
casting bore. A wire with a hook formed on the
end may be used, Fig. 13-44.
b. Installation
1. Check front head casting bore for carbon
chips of old seal or other foreign material. Clean
bore thoroughly before installing new seal.
-Wk*
mm^.
m«>
Snap Ring Pliers
J-5403 (^
Seal Seat
Retainer Ring
Seal Remover And
Installer J-9392
Fig, 13-41 Removing Seal Seat Retainer Ring Fig. 13-43 Removing Shaft Seal Assembly