Cadillac 60 Series 1963 Shop Manual page 201

9-8
ENGINE MECHANICAL
Fig. 9-8 Harmonic Balancer Assembly Installation
10. Install four pulley to harmonic balancer cap
screws that were previously removed and tighten
all six screws to 18 foot-pounds.
11. Install harmonic balancer assembly on
crankshaft, lining up key slot in harmonic bal-
ancer with key on crankshaft.
12. Place Holding Base, J-21052-1, against
front face of pulley and thread Installer Screw,
J-21052-5, into end of crankshaft, with Thrust
Bearing between holding base and Installer Nut,
J-21052-6, Fig. 9-8.
13. Using a 7/8 inch wrench, install harmonic
balancer assembly on crankshaft.
NOTE: Use of shop air pressure, as ex-
plained in removal procedure, will make it
possible to install harmonic balancer assembly
without crankshaft turning over.
14. When harmonic balancer assembly is ap-
proximately positioned on crankshaft, remove
Harmonic Balancer Remover and Installer Tool.
Thread a 1962 harmonic balancer-to-crankshaft
screw and washer in end of crankshaft. Tighten
screw to 125 foot-pounds.
15. Remove screw and washer from end of
crankshaft, install cork plug in end of crankshaft,
exhaust air pressure from cylinder, remove
Adapter, J-9388, and install previously removed
spark plug.
16. Install fuel pump as described in Section
10, Note 15.
17. Install power steering pump with bracket on
cylinder block and secure with two attaching
screws.
18. Install radiator as described in Section 11,
Note 9.
Cap
Screw
Oil Filter Support Bracket
Water Pump
Hex Head Plug
Regulator Valve
Spring
Copper O-Ring
Oil Pump Cover Plate
Screw
Fig. 9-9 Engine Front Cover Disassembled