Lighting Unit; Replacing Front Led; Replacing Headlight (Led) - Invacare Storm4 Series Service Manual

Installing
1. Remove rear and centre shroud. See 6.6.1 Replacing
Rear Shroud, page 21 and 6.6.2 Replacing Centre Shroud,
page 22.
2. Lead cables on power module and actuator module
fitted at rear through recess in battery flap under
actuator module to cable bridge (1).
3. Lead cables inside shrouds over cable bridge (1).
4. Fasten cables with cable clamps (2). Cable clamps on
front side of battery box for lifter cables (optional) are
not seen in picture.
5. Motor cables are fitted with protection shrouds (2) and
are guided out of front shroud through recesses on side.
6. Cables that lead to seat (upper actuator module, remote,
headlight), are guided out of front shroud through an
upper left recess (3).
7. Make sure cable has enough play so that all movable
parts can move freely without stretching, clamping or
abrading cable.
8. Lay cables in same way under seat and to remote.
Fasten cables with prescribed cable clamps or cable ties
respectively.

6.11 Lighting Unit

6.11.1 Replacing front LED

It is not intended for an individual LED to be replaced. Replace the entire lighting unit as described in Replacing headlight
(LED) or 6.11.3 Replacing Headlight Holder (LED), page 50.

6.11.2 Replacing Headlight (LED)

• 4 mm Allen key
• Oblique pliers
• Tie wraps
1555830-C
Fig. 6-44
Fig. 6-45
Service
49