Checking Cables; Lighting Unit; Replacing Headlight (Led Light) - Invacare Kite Series Service Manual

Installing Main Fuse
1. Replace strip fuse.
2. Install parts in reverse order.
Make sure to press two parts of fuse holder shroud together until it snaps.
If older fuse holder is used, lock fuse holder with UL94V0 cable tie.
3. Test all functions.

6.11.5 Checking Cables

1. Turn off electronics on remote.
2. Remove rear shroud. See 6.6 Shrouds, page 21.
3. Remove batteries. See 6.11 Batteries, page 49.
4. Check all cables for visible damage, crushing points or abrasion points.
5. Replace damaged cables.
6. Pull on each plug carefully. The plug must not come out of its socket when pulled on lightly.
7. If a plug is loose, apply slight pressure to push plug into socket. The plug must snap in place securely.
8. Check that plug is firmly attached to its socket.
9. Install parts in reverse order.
10. Test all functions.

6.12 Lighting unit

6.12.1 Replacing Headlight (LED Light)

Replacing an individual LED is not possible. If there is a defect, replace the entire front headlight.
• 7 mm wrench
• 3 mm Allen key
• Oblique pliers
• Tie wraps
Removing Headlights
1. Turn off electronics on remote.
2. Remove rear and the middle shrouds. See 6.6 Shrouds, page 21.
Take exact note of positions of all cables and sockets that they are connected to. Mark connectors and sockets or
take a photograph with a digital camera.
3. Disconnect plug of headlight from lighting circuit board (PCB).
4. Pull headlight cable out of wheelchair. If necessary, also remove tie wraps.
5. Remove front headlight plug from lighting PCB.
6. Free cable or remove any tie wraps.
7. Loosen nut (2).
8. Remove headlight (1) from lamp holder (3).
Installing Headlights
1. Install parts in reverse order
2. Test all functions.
1552415-K
Fig. 6-57
Service
53