Invacare Storm4 Series Service Manual page 65

1. Loosen and remove nut J including washer I.
2. Remove bolt B and belt D. Pay attention to washers
(C and F) and nut E.
Installing Lap Belt
• 4 mm Allen key
• 10 mm wrench
1. Insert pre-assembled lap belt H into installation hole A.
2. Insert washer I and nut J.
3. Tighten nut J.
Replacing Harness Belt (H-Belt)
• 5 mm Allen key
• 13 mm wrench
1. Remove plastic cap (2).
2. Loosen and remove screw (6), associated washers (5)
and nuts (4) (in front of the/behind the gripper clamp
(3)).
3. Replace harness belt (1).
4. Install new parts in reverse order.
5. Test all functions.
Replacing Lap Belt (H-Belt)
See Removing Lap Belt and Installing Lap Belt.
1555830-C
Fig. 6-83 Example of a lap belt on a Storm
Fig. 6-84
Fig. 6-85 Example of a lap belt on a Storm
Fig. 6-86
Service
4
4
65