Shrouds; Replacing Rear Shroud - Invacare Storm4 Series Service Manual

Component
Lighting (if installed)
Battery mounting
Batteries
Remote / electronics
modules
Drive program
Screws

6.6 Shrouds

6.6.1 Replacing Rear Shroud

Removing Rear Shroud
1. Loosen and remove two knurled thumb screws (1) on
left and right side of rear shroud.
2. Carefully raise rear shroud.
3. Front part of shroud is held at top by hook-and-loop
strip.
4. You must also release this.
Installing Rear Shroud
1. Install parts in reverse order.
2. Tighten knurled thumb screws finger-tight.
1555830-C
Check
Check cable
Check function
Check battery support
and mounting belts for
damage
Check batteries for
damage
Check battery voltage
Check contacts and
terminals
Remote, status display
blinking
Fixings
Cables and connecting
plugs
Joystick function
Power supply
Check drive electronics
program version
Check screws for tight
fit
Remedy
Replace lamp or cable
if necessary
Replace if necessary
Replace batteries if
necessary
Charge batteries
Clean contacts and
terminals
Evaluate error/blink
code
Tighten fixings, replace
if necessary
Tighten cables and
connecting plugs,
replace if necessary
Replace joystick knob if
necessary
Replace remote if
necessary
Tighten cables and
connecting plugs,
replace if necessary
Update software if
newer version available
Tighten screws if
necessary
Notes
See 6.11 Lighting Unit, page 49.
See 6.10.4 Removing Batteries,
page 46 and 6.10.2 How to Handle
Damaged Batteries Correctly, page
45.
See user manual.
See safety information under 6.10.4
Removing Batteries, page 46 and
6.10.2 How to Handle Damaged
Batteries Correctly, page 45.
See corresponding remote and
controls manual.
See 6.9.8 Updating software, page
44.
Fig. 6-2
Service
21