Replacing Calf Pads - Invacare Storm4 Series Service Manual

Invacare® Storm⁴ Series
1. Loosen four screws on both sides of footboard holder.
2. Pull out lower footboard assembly out of footboard
holder.
3. Heat thread of screw from upside direction (see arrow)
to soften thread locking adhesive. Loosen and remove
screw F.
4. Repeat previous step on second side.
5. Remove footboard assembly A including washers C
and D.
6. Loosen and remove screws G and covering sheet B.
7. Install parts in reverse order. Ensure to install screw F
with new thread locking adhesive.
8. Insert lower footboard assembly into footboard holder.
9. Adjust lower footboard assembly to desired height. See
4.3 Adjusting Fixed Footboard, page 9 .

6.14.3 Replacing Calf Pads

Replacing Calf Support
• 6 mm Allen key
1. Remove seat plate. See 6.12.1 Replacing Seat Frame,
page 52.
2. Remove calf pad.
3. Loosen and remove screws D including Nord-Lock
washers E and calf support C.
4. Remove T-nut A.
5. Install parts in reverse order. Ensure correct installation
of T-nut A and calf support C on seat frame B.
6. Test all functions.
Replacing Calf Pad
• 4 mm Allen key
1. Loosen screws A.
2. Pull off calf pad C from calf support B.
3. Install parts in reverse order.
4. Adjust position and angle of calf pad to user needs. See
user manual.
58
Fig. 6-64
Fig. 6-65
Fig. 6-66
1555830-C