Resetting Circuit Breaker; Lighting Unit; Replacing Headlight; Replacing Rear Light - Invacare Mirage Service Manual

5.9.4 Resetting Circuit Breaker

If the mobility device cannot be turned on, check whether
the safety cutout has triggered. The safety cutout is reset by
pressing the knob inwards.
See user manual.

5.10 Lighting unit

5.10.1 Replacing Headlight

Replacing Headlight
See corresponding light manual.
Removing Headlight Holder
1. Loosen screw C.
2. Pull holder D out off remote bracket B.
3. If necessary, loosen hand screw A and remove remote
bracket B.
Installing Headlight Holder
1. Install parts in reverse order.
2. Test correct installation.

5.10.2 Replacing Rear Light

See corresponding light manual.

5.11 Seating

This manual refers to configurations with standard seat
system.
For other seat systems (for example Modulite), refer to the
corresponding manual.

5.11.1 Replacing Backrest Unit

Replacing Backbrace
1. Remove both hand screws A on backrest unit.
2. Remove back brace B.
3. Install parts in reverse order.
1441763-E
Fig. 5-20
Fig. 5-21
Replacing Handle
1. Remove backbrace.
2. Remove defective handle C.
3. Install parts in reverse order.
Replacing Backrest Upholstery
This mobility device is delivered with different upholsteries.
If a recliner backrest is installed, it may be necessary to
remove the gasspring and lower section of the backrest
tubes to completely remove the upholstery.
• Phillips screwdriver, size 2
1. Remove backbrace and handle.
2. Remove screws D including rosette.
3. Remove both backrest tubes from chassis.
4. Replace Backrest Upholstery E.
Replacing Backrest tubes
1. Remove backbrace, handle and upholstery.
2. Lossen lever D on chassis C.
Replacing Fabric Seat (Padded)
Fig. 5-23 Schematic representation of a padded fabric seat
Fig. 5-22
Service
25