Seating; Replacing Seat Frame - Invacare Storm4 Series Service Manual

Invacare® Storm⁴ Series
5. Loosen nut (1).
6. Lift off rear light shroud (2) carefully.
7. Open rear light plug (3) that is to be replaced.
8. The rear lights are only clamped in plastic casing.
Replace red rear light (1) or indicator (2) as required.
Cables are marked correspondingly.
Installing Rear Light
1. Install all parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Test all functions.

6.12 Seating

This manual refers to configurations with standard seat system.
For other seat systems (for example Modulite), refer to the corresponding manual.

6.12.1 Replacing Seat Frame

CAUTION!
Risk of strain from lifting heavy parts!
– Use proper lifting techniques.
• 6 mm Allen key
• 24 mm open-ended wrench
• Oblique pliers
• Cable ties
Removing Seat Frame
1. Remove any existing cable ties holding cables on remote
or lighting. Remove cables from stuck on clamps.
2. Loosen cap nuts of headlight mountings. See 6.11
Lighting Unit, page 49.
3. Put headlight and mounting in safe place on rear part of
battery compartment shroud.
4. Remove all cables between seat and chassis.
5. Remove seat cushion.
6. Remove parts that are in the way, such as legrests and
armrests.
7. Loosen two screws A and remove seat plate B.
8. Remove backrest unit. See 6.16.5 Replacing Backrest
Bracket, page 63.
52
Fig. 6-51
Fig. 6-52
Fig. 6-53
1555830-C