Replacing Backrest Bracket - Invacare Storm4 Series Service Manual

1. Remove backrest frame and backrest tube. See 6.16.3
Replacing Backrest Rail, page 61.
2. Loosen four screws D on each side. Do not unscrew
them.
3. Remove backrest rail A by pulling it upwards.
4. Loosen set screw A.
5. Lift off adapter E from backrest bracket.
6.
Ensure that guide C is on outside and T-nut B
is on inside of slot
Install parts in reverse order.
7. Test all functions.

6.16.5 Replacing Backrest Bracket

• 5 mm Allen key
• 6 mm Allen key
• Flat screwdriver
1. Loosen handscrews / screws A on both sides and
remove upper backrest assembly.
2. Remove retainer clip C.
3. Keep firm hold on backrest bracket B whilst removing
pin D and laying down actuator / spindle E.
4. Secure backrest bracket B against falling down.
1555830-C
Fig. 6-76
Fig. 6-77
Fig. 6-78 Example of Max seat with installed seat depth adapter
Fig. 6-79
Service
63