Posture Belt; Replacing Posture Belt - Invacare Storm4 Series Service Manual

Invacare® Storm⁴ Series
5. Loosen and remove screws J including washers L and
bushings K on both sides.
6. Remove backrest bracket B.
7. Loosen and remove screws I, washers H, cover plates
G and bearing sheet F on both sides.
8. Install parts in reverse order.
9. Test all functions.

6.17 Posture Belt

6.17.1 Replacing Posture Belt

Pre-Assembling Belts
Another nut E is installed in installation hole A between washers as a spacer, so that the belt bracket can
move freely.
1. Install parts in following order:
• Bolt B,
• washer C,
• belt D,
• spacer nut E, and
• washer F.
Removing Lap Belt
• 4 mm Allen key
• 10 mm wrench
64
Fig. 6-81 Lap Belt installation hole on Max seat
Fig. 6-80
Fig. 6-82
1555830-C