Changing Bulbs - Mercedes-Benz Sprinter 2019 Operating Instructions Manual

Hide thumbs Also See for Sprinter 2019:
Table of Contents

Advertisement

Rear interior lighting
1
Switches rear compartment/cargo com‐
#
partment lamp on or off
Motion detector
& WARNING Risk of injury by laser beam
from motion detector
The motion detector transmits invisible radia‐
tion from LEDs (light-emitting diodes).
These LEDs are classified under the 1M laser
class and can cause retina damage in the fol‐
lowing situations:
If you look directly into the unfiltered
R
laser beam from the motion detector for
an extended period
If you look directly into the laser beam of
R
the motion detector with optical instru‐
ments such as eyeglasses or a magnifying
glass.
Never look directly into the laser beam.
#
The motion detector is located in the cargo com‐
partment behind the partition, in the middle of
the roof.
Light and vision
1
Position of motion detector
If the vehicle is equipped with a motion detector,
the cargo compartment lighting is also activated
via the motion detector.
If the motion detector detects movement in the
cargo compartment while the vehicle is station‐
ary, the cargo compartment lighting switches on
for approximately two minutes.
The cargo compartment lighting can be switched
on via the motion detector if:
The vehicle is stationary, the parking brake is
R
applied and the brake pedal is not being
depressed.
Vehicles with automatic transmission: the
R
selector lever is in position j and you are
not depressing the brake pedal.
The vehicle has not been locked from the out‐
R
side using the key.
If no change to the vehicle, such as a door open‐
ing, is detected over several hours, the motion
detector will automatically switch off. This pre‐
vents the battery from discharging.

Changing bulbs

Instructions for changing bulbs
& WARNING Risk of burns from hot com‐
ponent parts whilst replacing a bulb
Bulbs, lamps and plug connectors can
become very hot during operation.
When replacing a bulb, you could burn your‐
self on these component parts.
Allow the component parts to cool
#
down before replacing the bulbs.
83

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents