Table of Contents
Advertisement
224 Wheels and tires
Otherwise, the rods could bend and deform so
much that they can no longer be used as pump
levers for the jack.
To prepare the hydraulic jack: insert the
#
third rod of pump lever
the lug wrench extension.
Close pressure release screw 3.
#
To do this, use the flattened section on pump
#
lever
1
to turn pressure release screw
clockwise to the stop.
%
Do not turn pressure release screw
than one or two full turns. Hydraulic fluid
could otherwise escape.
Insert pump lever
1
with the largest rod into
#
the recess on the jack and secure by turning
it clockwise.
Place the jack vertically beneath the jack sup‐
#
port points described below.
Jack support point, front axle
1
for the jack into
3
3
more
Jack support point, rear axle (example: chassis
up to 3.5 t)
Jack support point, rear axle (example: Cargo
Van and Passenger Van up to 4.0 t)
Jack support point, rear axle (vehicles 5.0 t)
Hide quick links:
Advertisement
Table of Contents
