Mercedes-Benz Sprinter 2019 Operating Instructions Manual page 86

Hide thumbs Also See for Sprinter 2019:
Table of Contents

Advertisement

84
Light and vision
When replacing the bulb, comply with the follow‐
ing:
Do not use any bulb that has been dropped or
R
has scratches on its glass tube. Otherwise,
the bulb may explode.
The bulb may explode if you touch it, if it is
R
hot, if you drop it or if you scratch it.
Stains on the glass tube reduce the bulb's
R
service life. Do not touch the glass tube with
your bare hands. If necessary, clean the glass
tube with alcohol or spirits in a cold state and
wipe it down with a lint-free cloth.
Protect bulbs from humidity and do not bring
R
them into contact with liquids.
Always ensure the bulbs are firmly secured.
If you vehicle is equipped with LED lamps, you
can check this as follows: the light cone will move
from top to bottom and back again when the
engine starts. For this to work, the low beam
needs to have been switched on before the
engine is started.
Bulbs and lights are a major element in vehicle
safety. Therefore, ensure that they are always
working. Have the headlamp setting checked reg‐
ularly.
Before changing the lamps, switch off the
R
vehicle's lighting system. You can thus avoid
a short circuit.
Use bulbs only in closed lights that have been
R
designed for them.
Use only spare bulbs of the same type and
R
with the correct voltage.
If the new bulb also does not light up, consult a
qualified specialist workshop.
Replacing front light bulbs (vehicles with hal‐
ogen headlamps)
Overview of front bulb types
You can change the following bulbs.
Halogen headlamps
1
High beam/daytime running lamps:
H15 55 W/15 W
2
Low beam/perimeter light: H7 55 W/W 5 W
3
Turn signal: 3457 NAK 28 W
Changing the halogen headlamp
Requirements:
Low beam: light bulb type H7 55 W
R
High beam/daytime running lamps: light
R
bulb type H15 55 W/15 W
Perimeter lights: light bulb type W 5 W
R
Turn signals: bulb type 3457 NAK 28 W
R
1
Housing cover/low beam/perimeter lights
2
High beam/daytime running lamps housing
cover
3
Turn signal socket
Switch off the lighting system.
#

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents