Table of Contents
Advertisement
70
Seats and stowage
Pull release handle
1
for the seat backrest
#
upwards and hold it in position.
Move the seat backrest to the desired posi‐
#
tion.
Let go of release handle
#
rest and move the seat backrest slightly.
The seat backrest engages in position.
Head restraints
Adjusting the head restraints manually
& WARNING Risk of injury from adjusting
the vehicle settings while the vehicle is in
motion
You could lose control of the vehicle in the
following situations:
if you adjust the driver's seat, the head
R
restraint, the steering wheel or the mirror
while the vehicle is in motion
if you fasten your seat belt while the vehi‐
R
cle is in motion
Before starting the engine: adjust the
#
driver's seat, the head restraint, the
steering wheel or the mirror and fasten
your seat belt.
& WARNING Risk of injury due to head
restraints which are not installed or are
adjusted incorrectly
If head restraints are not installed or are
adjusted incorrectly, the head restraints can‐
not provide protection as intended.
There is an increased risk of injury in the
head and neck area, e.g. in the event of an
accident or when braking.
Always drive with the head restraints
#
installed.
Before driving off, make sure for every
#
vehicle occupant that the center of the
head restraint supports the back of the
head at about eye level.
Do not swap the head restraints of the front and
rear seats. Otherwise, you will not be able to set
the height and inclination of the head restraints
to the correct position.
Using the head restraint fore/aft adjustment,
adjust the head restraint in such a way that it is
as close to the back of the head as possible.
1
for the seat back‐
Head restraint (example of comfort head restraint
on the driver's seat)
#
#
#
#
%
Switching the seat heating on and off
& WARNING Risk of burns due to repeat‐
To raise: pull the head restraint upwards into
the required position and ensure that the
head restraint is engaged.
Only use the head restraint in the engaged
state.
To lower: push release button
the head restraint downwards into the
required position and ensure that the head
restraint is engaged.
Only use the head restraint in the engaged
state.
To move forwards: push release button
and pull the head restraint forwards until it
engages in the required position.
To move backwards: push release button
and slide the head restraint backwards into
the required position.
Depending on the head restraint model, indi‐
vidual adjustment options may be omitted.
edly switching on the seat heating
Repeatedly switching on the seat heating can
cause the seat cushion and seat backrest
padding to become very hot.
The health of persons with limited tempera‐
ture sensitivity or a limited ability to react to
high temperatures may be affected or they
may even suffer burn-like injuries.
Do not repeatedly switch on the seat
#
heating.
1
and slide
2
2
Hide quick links:
Advertisement
Table of Contents
