Mercedes-Benz Sprinter 2019 Operating Instructions Manual page 82

80 Light and vision
Operating the combination light switch
1
High beam
2
Right indicator
3
High-beam flasher
4
Left turn signal
To indicate: push the combination switch in
#
required direction 2 or
In the case of larger steering movements, the
combination switch automatically switches
back.
To indicate briefly: tap the combination
#
switch briefly in required direction
The corresponding turn signal light flashes
three times.
To switch on the high beam: switch on the
#
low beam ( → page 79).
Press the combination switch forwards 1.
#
The K indicator lamp on the instrument
cluster will light up. The combination switch
will return to its starting position.
%
The high beam switches to position Ã
only in darkness and when the engine is run‐
ning.
To switch off the high beam: push combina‐
#
tion switch 1 forwards or briefly pull it in the
direction of arrow 3 (the high-beam flasher
switches the high beam off).
The K indicator lamp on the instrument
cluster will go out. The combination switch
will return to its starting position.
%
Vehicles with Highbeam Assist: when
Highbeam Assist is active, it controls the
activation and deactivation of the high beam
( page 81).
→
#
#
Switching hazard warning lights on or off
#
4 until it engages.
If you operate a turn signal while the hazard
warning lights are switched on, only the turn sig‐
nal on the relevant side of the vehicle lights up.
If the hazard warning lights have automatically
2 or 4.
switched on, press the hazard warning lamp
switch
%
Cornering light function
Cornering light improves the illumination of the
road over a wide angle in the turning direction,
enabling better visibility in tight bends, for exam‐
ple.
To activate the high-beam flasher: switch
on the power supply or ignition.
Briefly pull the combination switch in the
direction of arrow 3.
To switch on and off: press button 1.
1 to switch them off.
The hazard warning lights work even when
the ignition is switched off.