Spare Wheel - Mercedes-Benz Sprinter 2019 Operating Instructions Manual

Hit the middle of the hub cap to engage it on
#
the wheel.
Secure the defective wheel in the spare wheel
#
bracket.
Vehicles with Super Single tires: transport
#
the defective rear wheel in the load area. The
rear wheel is too large for the spare wheel
bracket.
Check the tire pressure of the newly installed
#
wheel and adjust it if necessary.
Retighten the wheel bolts or wheel nuts to the
#
specified tightening torque after the vehicle
has been driven 31 miles (50 km).
When using a wheel or spare wheel with a
#
new or newly painted wheel rim, have the
wheel bolts or nuts retightened after approx‐
imately 620 miles (1000 km) to 3100 miles
(5000 km).
% Vehicles with the tire pressure monitor
system: all installed wheels must be equip‐
ped with functioning sensors.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
R

Spare wheel

Notes on the spare wheel
& WARNING Risk of accident caused by
incorrect wheel and tire dimensions
Wheel and tire dimensions as well as the type
of tire may vary between the spare wheel and
the wheel to be replaced. When the spare
wheel is installed, driving characteristics may
be severely affected.
To prevent hazardous situations:
Adapt your driving style accordingly and
#
drive carefully.
Never install more than one spare wheel
#
that differs from the wheel to be
replaced.
Only use the spare wheel that differs
#
from the wheel to be replaced for a
short time.
Do not switch off ESP
#
Have the spare wheel of a different size
#
replaced at the nearest qualified spe‐
cialist workshop. The wheel and tire
Do not exceed a maximum speed of 50 mph
(80 km/h) if a spare wheel of a different size is
installed.
page 206)
→
%
Regularly check that the spare wheel is secured
and has the specified tire pressure (
®
.
Regularly check the following, particularly prior to
long trips:
R
Wheels and tires 227
must have the correct dimensions and
the tire must be the correct type.
& WARNING Risk of accident from dam‐
aged spare wheel with Super Single tires
Vehicles with Super Single tires
The tire of the spare wheel exposed to above-
average loads after being installed on the rear
axle. If you exceed the maximum speed or the
maximum distance, or install the spare wheel
again, the tire of the spare wheel may be
damaged. The tire damage may not be visible
and not detectable.
A damaged tire may cause a loss of tire pres‐
sure. This could cause you to lose control of
the vehicle.
Only use the spare wheel if it has not
#
yet been installed on the rear axle with
the current tires.
If the spare wheel had been installed on
#
the rear axle, have the tire of the spare
wheel replaced after changing the
wheel again, irrespective of the dis‐
tance.
For safety reasons, when changing a tire
#
ensure that only the tire valve type
approved for the tires is used.
* NOTE Damage to the transmission
Vehicles with Super Single tires: when you
install the spare wheel on the rear axle, the
transmission may be damaged by the differ‐
ent rotational speeds of the wheels.
When the spare wheel is installed on the
#
rear axle, observe the maximum speed
of 34 mph (55 km/h) and the maximum
driving distance of 62 miles (100 km).
The spare wheel can be used without restric‐
tions on the front axle of a vehicle with Super
Single tires.
the tire pressure of the spare wheel (if neces‐
sary, adjust the tire pressure).
page 206).
→