Signals To Axis/Spindle (Db31 - Siemens SINUMERIK Series Function Manual

Z2: NC/PLC interface signals
18.3 Manual and Handwheel Travel (H1)
DB21, ...
DBX37.0 Handwheel 1 active as contour handwheel
DBX37.1 Handwheel 2 active as contour handwheel
DBX37.2 Handwheel 3 active as contour handwheel
Edge evaluation: No
Description These signals show which handwheel is selected as contour handwheel:
Signal = 1
Signal = 0
Special cases, The signal is kept beyond an NC Reset.
errors, ...
Corresponding to ... DB21, ... DBX30.0, 30.1, 30.2 (handwheel x active as contour handwheel)
DB21, ...
DBX39.5 Handwheel direction of rotation inversion active for contour handwheel
Edge evaluation: No
Description This signal indicates whether the direction of rotation was inverted for the contour handwheel:
Signal = 1
Signal = 0
Corresponding to ... DB31, ... DBX31.5 (invert handwheel direction of rotation for the contour handwheel)
18.3.5

Signals to axis/spindle (DB31, ...)

Description of signals to axis/spindle
DB31, ...
DBB4
Bit 0-2 Activate handwheel (1 to 3)
Edge evaluation: No
Signal state 1 or This PLC interface signal defines whether this machine axis is assigned to handwheel 1, 2, 3 or no
edge change 0 → 1 handwheel.
Only one handwheel can be assigned to an axis at any one time.
If several interface signals:
DB31, ... DBX4.0, 4.1, 4.2 (Activate handwheel)
are set, priority "Handwheel 1" before "Handwheel 2" before "Handwheel 3" applies.
If the assignment is active, the machine axis can be traversed with the handwheel in JOG mode or
a DRF offset can be generated in AUTOMATIC or MDA mode.
Signal state 0 or Neither handwheel 1, 2 nor 3 is assigned to this geometry axis.
edge change 1 → 0
Application The PLC user program can use this interface signal to disable the influence of turning the
example(s) handwheel on the axis.
Corresponding to ... DB31, ... DBX64.0 to DBX64.2 (Handwheel active)
876
Signal(s) updated: Cyclic
Handwheel x is selected as contour handwheel.
Handwheel x is deselected as contour handwheel.
Signal(s) updated: Cyclic
The direction of rotation of the contour handwheel is inverted.
The direction of rotation of the contour handwheel is not inverted.
Signal(s) updated: Cyclic
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions