Grinding-Specific Tool Offset And Tool Monitoring (W4); Signals From Axis/Spindle (Db31 - Siemens SINUMERIK Series Function Manual

Z2: NC/PLC interface signals

18.17 Grinding-specific tool offset and tool monitoring (W4)

18.17 Grinding-specific tool offset and tool monitoring (W4)
18.17.1

Signals from axis/spindle (DB31, ...)

DB31, ...
DBX83.3 Geometry monitoring
Edge evaluation: No
Signal state 1 or Error in grinding wheel geometry.
edge change 0 → 1
Note:
There is no further reaction to the response of this monitoring function.
Reactions deemed necessary must be programmed by the PLC user.
Signal state 0 or No error in grinding wheel geometry.
edge change 1 → 0
Application Grinding-specific tool monitoring
example(s)
DB31, ...
DBX83.6 Speed monitoring
Edge evaluation: No
Signal state 1 or Error in grinding wheel speed.
edge change 0 → 1
Note:
No further reaction to this signal state is programmed.
Reactions deemed necessary must be programmed by the PLC user.
Signal state 0 or No error in grinding wheel speed.
edge change 1 → 0
Application Grinding-specific tool monitoring
example(s)
DB31, ...
DBX84.1 GWPS active
Edge evaluation: No
Signal state 1 or Constant grinding wheel peripheral speed (GWPS) is active.
edge change 0 → 1
If GWPS is active, then all S value inputs from the PLC are interpreted as the grinding wheel
peripheral speed.
Signal state 0 or Constant grinding wheel peripheral speed (GWPS) is not active.
edge change 1 → 0
Application GWPS in all operating modes.
example(s)
908
Signal(s) updated: -
Signal(s) updated: -
Signal(s) updated: -
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions