Restrictions - Siemens SINUMERIK Series Function Manual

Delete distance-to-go
After traversing to the next possible indexing position, the movement is aborted at this
position.
Command axes
If
MOV=0
possible indexing position.
References:
Function Manual, Synchronized Actions
MOV command
MOV=1
MOV=0
DELDTG command
In the case of indexing axes without Hirth tooth
system:
In the case of indexing axes with Hirth tooth
system:
15.5.4

Restrictions

Transformations
The axis for which the Hirth tooth system is defined cannot take part in kinematic
transformations.
PRESET
The axis for which the Hirth tooth system is defined cannot be set to a new value with
PRESET
Revolutional feedrate
The axis for which the Hirth tooth system is defined cannot be traversed at revolutional
feedrate.
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
is specified for a moving command axis, the axis continues traversing to the next
Works on indexing axes with and without Hirth tooth system.
Same function for both: Approaches the next position.
.
15.5 Equidistant index intervals
Axis stops immediately.
Axis traverses to next position.
T1: Indexing axes
785