Output Values - Siemens SINUMERIK Series Function Manual

M5: Measurement
7.5 Setting zeros, workpiece measuring and tool measuring
Value
9
10 *
11 *
12
13
14
15
16
17
18
19
20
21
22 *
23 *
24
25
26
27
28
* Types of workpiece measurement
The individual methods are listed under "Types of workpiece measurement" or "Types of tool
measurement"and explained in more detail using an appropriate programming example.
7.5.2.3

Output values

Calculation results
If a setpoint position has been specified, the resulting frame is entered in result frame
$AC_MEAS_FRAME. This frame can be read and written in the part program. The result
frame is calculated according to the selected frame.
If no frame has been selected, the result frame determines the final translation and rotation
in the WCS. This frame can be entered in the selected frame using the PI service
_N_SETUDT and parameter type no. 7. Once it has been entered, the result frame is
deleted.
Table 7- 4
Type
FRAME
REAL
460
Stud
Tool length
ToolDiameter
Slot
Plate
Set_Pos
Set_AuxPos
Edge_2P
Plane_Angles
Plane_Normal
Dimension_1
Dimension_2
Dimension_3
ToolMagnifier
ToolMarkedPos
Coordinate transformation
Rectangle
Save
Restore
Taper turning
Output values of calculation results
System variable
$AC_MEAS_FRAME
$AC_MEAS_WP_ANGLE
Description
Measuring a shaft
Measuring the tool length
Measuring the tool diameter
Measuring a groove
Measuring a web
Preset actual value for geometric and special axes
Preset actual value memory for special axes only
Measuring an inclined edge
Angle of a plane
Angle of a plane with setpoint input
1-dimensional setpoint value
2-dimensional setpoint value
3-dimensional setpoint value
ShopTurn: Measurement of tool lengths with zoom-in
function
ShopTurn: Measuring a tool length with marked position
Coordinate transformation of a position
Measurement of a rectangle
Saving data management frames
Restoring data management frames
Additive rotation of the plane
Description
Result frame
Calculated workpiece position angle α
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions