Parameter Sets Of Axis/Spindle - Siemens SINUMERIK 840Di sl Commissioning Manual

Interface signals
Table 11-30 Indexing axes: Interface signals
DB number Bit, byte
Axis/spindle-specific
31,... 60.4, 60.5
31,... 76.6
References:
/FB/ Function Manual, Extended Functions,T1 Indexing axes
11.5.13

Parameter sets of axis/spindle

Per machine axis, six parameter sets are available. They serve the following purpose:
● on an axis:
● on a spindle:
Tapping, thread cutting
The following applies to axes:
● For a machine axis that is not involved in tapping or thread cutting, the 1st set of
● Machine axes involved in tapping or thread cutting: the parameter set is activated in
The following applies to spindles:
● With spindles, each gear stage is assigned a parameter set of its own. The parameter set
For example, in HMI Advanced, the active parameter set of a machine axis is displayed in
the control area "DIAGNOSIS" in the screen form "Service Axis".
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Name
Signals from axis/spindle to PLC
Referenced/synchronized 1, referenced/synchronized 2
Indexing axis in position
for accommodation of the own dynamic response to another machine axis, e.g. when
tapping or thread cutting on the relevant spindle.
for accommodation of the position controller to modified properties of the machine during
operation, e.g. when switching the gearbox.
parameters (index=0) is active in all cases.
The further parameter sets need not be considered.
accordance with the current gear stage.
All parameter sets must be parameterized in accordance with the gear stages of the
spindle.
is selected by the PLC via the interface signal DB31, ... DBX16.0 - 16.2 (actual gear
stage).
All parameter sets must be parameterized in accordance with the gear stages of the
spindle.
NC Commissioning with HMI Advanced
11.5 Axes and spindles
411