Siemens SINUMERIK Series Function Manual page 510

M5: Measurement
7.5 Setting zeros, workpiece measuring and tool measuring
The values of the following input variables are evaluated for measurement type 23:
Input variable
$AC_MEAS_VALID
$AA_MEAS_POINT1[axis]
$AC_MEAS_P1_COORD
$AA_MEAS_SETPOINT[axis]
$AC_MEAS_SET_COORD
$AC_MEAS_ACT_PLANE
$AC_MEAS_T_NUMBER
$AC_MEAS_D_NUMBER
$AC_MEAS_TOOL_MASK
$AC_MEAS_DIR_APPROACH
$AC_MEAS_INPUT[0] = 1
$AC_MEAS_TYPE
* optional
The following output variables are written for measurement type 23:
Output variable
$AC_MEAS_RESULT[0]
$AC_MEAS_RESULT[1]
$AC_MEAS_RESULT[2]
$AC_MEAS_RESULT[3]
$AC_MEAS_RESULT[4]
$AC_MEAS_RESULT[5]
510
Description
Validity bits for input variables
Current or marked position
Coordinate system of the measuring point *
Setpoint position (minimum one geo axis must be specified)
Coordinate system of setpoint *
Calculated as active plane unless otherwise specified *
Calculated as active T unless otherwise specified (T0) *
Calculated as active D unless otherwise specified (D0) *
Tool position, radius *
Approach direction *
the calculated tool lengths are written to the data management *
23
Description
Tool length in x
Tool length in y
Tool length in z
Tool length L1
Tool length L2
Tool length L3
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions