Measurement Of Geo Axes And Special Axes (Measurement Type 14, 15) - Siemens SINUMERIK Series Function Manual

The following output variables are written for measurement type 13:
Output variable
$AC_MEAS_FRAME
$AC_MEAS_RESULTS[0]
$AC_MEAS_RESULTS[1]
7.5.3.7

Measurement of geo axes and special axes (measurement type 14, 15)

Preset actual value memory for geo axes and special axes ($AC MEAS TYPE = 14)
This measurement type is used on the HMI operator interface.
Figure 7-10
The values of the following variables are evaluated for measurement type 14:
Input variable
$AC_MEAS_VALID
$AA_MEAS_POINT1[axis]
$AA_MEAS_SETPOINT[axis]
$AC_MEAS_ACT_PLANE
$AC_MEAS_FINE_TRANS
$AC_MEAS_FRAME_SELECT
$AC_MEAS_T_NUMBER
$AC_MEAS_D_NUMBER
$AC_MEAS_TYPE
* optional
The following output variables are written for measurement type 14:
Output variable
$AC_MEAS_FRAME
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
7.5 Setting zeros, workpiece measuring and tool measuring
Preset actual value memory
Meaning
Result frame with translation
Position of calculated web center (x0, y0 or z0)
Web width in approach direction
Meaning
Validity bits for input variables
Actual values of the axes
Setpoint position of the individual axes *
Calculated as active plane unless otherwise specified *
0: Coarse offset, 1: Fine offset *
Calculated as additive frame unless otherwise specified *
Calculated as active T unless otherwise specified (T0) *
Calculated as active D unless otherwise specified (D0) *
14
Meaning
Result frame with translations
M5: Measurement
481